HPS BRUSHLES SERIES HPS A700 21 mm 74,0 kgcm 0,12 sec. NEW Best Nr. P-HPS-A700 Abm: 40,5 x 21 x 39,4 mm Gewicht: 82 g HPS CB700 21 mm 49,0 kgcm 0,075 sec. NEW Best Nr. P-HPS-CB700 Abm: 40,5 x 21 x 37,8 mm Gewicht: 76 g HPS H700 21 mm 44,0 kgcm 0,07 sec. NEW Best Nr. P-HPS-H700 Abm: 40,5 x 21 x 37,8 mm Gewicht: 74 g HPS HC700 21 mm 20,0 kgcm 0,08 sec. NEW Best Nr. P-HPS-HC700 Abm: 40,5 x 21 x 37,8 mm Gewicht: 73 g HPS BRUSHLESS SERIES The new Futaba HPS series includes high performance servos for model aircraft, helicopters and RC cars. Technical data such as 74 kg of torque and 0.12 sec / 60 ° travel time at 7.4V are a clear announcement. For the HPS servos, a new HPS brushless motor was developed, which remains much cooler in operation. Together with the new HPS Technology results in a lower power consumption over the operating time. The new all-aluminum cases have a size of 40.5 x 21 x 37.7 (39.4) mm. The HPS servos, like any S.BUS2 servo, can be connected to all conventional PWM modulated receivers. In addition, the servos can be optimally adapted to their operating conditions by programming.. PROGRAMMABLE PARAMETERS • S.BUS channel assignment • servo reversal • soft start (on / off) • Mode selection in case of signal failure • Soft servo run (on / off) • servo position (servo tester) • Deadband setting • Servo center adjustment +/- 300 μs (about 30 degrees) • Servo speed, 0.39 ... 9 seconds per 45 degrees • servo travel adjustment separated left and right, approx. 50 ...175% • Starting power • Attenuation • holding power • ID-storage Futaba servo-series Futaba servo labels are de�ned by a numbering system for diffe- rent speci�cations. S.Bus2 servos can always be operated on all receiver outputs, whether S.Bus, S.Bus2, Servo Direct Outputs (PWM). Futaba currently builds only a few analog servos without S.Bus, all new servos come for 2 years always with S.Bus2, so they are always to operate at all receiver outputs. Operating voltage up to 6.0V with S.BUS operating voltage up to 8,4V (2 lipo cells) with S.BUS Remarks Operating voltage up to 6.0V Code/No. Servo type S-XXX Analog or digitalservos Digitalservos SB High voltage HV servo 2 Ball Bearings Always on the power take-off BB S.BUS-Servo S.BUS S.BUS2-Servo S.BUS2 brushless Servo Brushless motor, wear-free operation at each receiver + at S.BUS, not at S.BUS2 !!! operation on S.BUS and S.BUS2 + all receiver BLS 30 The new HPS servos